DCA Super Sabre Vanes- 40 Pack

DCA Super Sabre Vanes offer aerospace-tested control, elite durability, and unmatched consistency for serious archers.

PointPoint

PointsPoints

$21.99

% off Sold out

Color:

Product variants

Quantity

only 5 left in stock

Why we like this product

Designed using CFD, NASA stability models, and wind tunnel testing for elite performance
Ultra-durable material resists damage and maintains shape after impact
Individually molded with exceptional weight consistency of ±0.1 grains

Engineered through two years of scientific testing, the DCA Super Sabre Vanes bring aerospace-level performance to your arrow setup. Developed using Computational Fluid Dynamics (CFD), NASA stability calculations, and custom wind tunnel testing, these vanes are optimized for precision, control, and stability in real-world flight conditions. Each vane is individually molded for unmatched consistency, with a near-perfect weight tolerance of 7.1 ± 0.1 grains.

Made from the same ultra-tough material used on the exterior of golf balls, Super Sabres resist damage from pass-throughs and maintain shape after stretching. For a nearly permanent bond, use the Sabre Primer Pen and Bob Smith Maxi-Cure adhesive. This 40-pack is ready for serious shooters who demand consistency and durability at the highest level.

Weight	7.0 +/- 0.1 grains
Height	.55"
Length	2.25"

Clean the arrow shaft or wrap with a clean, dry paper towel. Do not use acetone.
Place Super Sabre in the fletching jig clamp. 2.5 degree helical is recommended as a starting point, but not required (left or right).
Prep the base using the Sabre Primer Pen for a rock solid almost permanent bond.
Apply a very thin continuous bead of Maxi-Cure to the base. Do not spread it out.
Using press the vane down holding it securely for 10 sec. (or recommended time on adhesive).
Unclamp the vane and wipe excess glue from around the base of the vane.
Let the adhesive cure for 10-15 min.