DCA Mini Sabre Vanes - 40 Pack

Scientifically engineered vanes with aerospace-tested design and unmatched durability for ultimate flight precision

PointPoint

PointsPoints

$21.99

% off Sold out

Color:

Product variants

Quantity

only 8 left in stock

Why we like this product

Molded design makes these super durable, no inconsistencies or warping
Made from the same durable material used on golf balls, these vanes can flex, return to shape, and handle pass-throughs with ease
Designed using CFD, NASA modeling, and wind tunnel testing for unmatched accuracy

Engineered through two years of testing and refinement, the Mini Sabre Vanes redefine vane performance and precision. Each vane is individually molded using an advanced 8-cavity system to ensure exact uniformity, delivering a consistent 6.0 ± 0.1 grain weight across every set. That means tighter tolerances, better flight control, and unmatched accuracy shot after shot. Built from the same ultra-tough material used on golf balls, the Mini Sabre is designed to flex, take impact, and return to shape without fail, even after pass-throughs on targets. Pair them with the Sabre Primer Pen and Bob Smith Maxi-Cure adhesive for an almost permanent bond that stands up to any condition. Scientifically developed using Computational Fluid Dynamics (CFD), NASA stability modeling, a custom wind tunnel, and LabRadar (Doppler radar) testing, the Mini Sabre delivers superior aerodynamics and flight stability. The result is a vane that’s tough, precise, and built to dominate in any hunting or target scenario.

Weight	6.0 +/- 0.1 grains
Height	.465"
Length	2"

Clean the shaft by wiping the arrow shaft or wrap with a clean, dry paper towel. Avoid using acetone.
Place the Sabre vane in your fletching jig clamp. A 2.5° helical (left or right) is a great starting point but not required
Use the Sabre Primer Pen to prepare the vane base for a strong, long-lasting bond
Add a thin, continuous bead of Maxi-Cure glue along the vane base. Do not spread it out
Press the vane firmly onto the shaft and hold for about 10 seconds (or per adhesive instructions)
Release the clamp and wipe away any extra glue from around the vane base
Allow the adhesive to fully cure for 10–15 minutes before handling or shooting